Farmall & IHC Tractors Discussion Board |
Re: Farmall H governer adjustment advice helped!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by WayneT on March 17, 2005 at 06:55:34 from (66.38.32.183):
In Reply to: Re: Farmall H governer adjustment advice helped!! posted by Glen Thibodeaux on March 16, 2005 at 20:04:40:
Lost the link ChadS sent me, but heres what I did. 1.I made dang sure the linkage and tube from the gov to carb is in that notch correctly. 2.I adjusted out the screw on the side of the carb near the tube from gov. 3. Removed side cover on gov. 4. With tractor shut off and throttle in its slowest setting I adjusted the top governeor set screw so it just touched the governor housing. 5. Pulled throttle wide open and adjusted the bottom set screw so it just touched the bottom. 6. I suspected that the carb butteryfly was not closing completely so I turned the "Y" or fork down one turn. Pull a pin and turn it down one turn clockwise. 7. Started tractor and I had to adjust that screw on the side to up slow idle rpm's a bit. Did not yet check RPM's, but at lowest idle purrs like a kitten at about 450 rpm's. With throttle wide open sounds right. I will probably get a new governor spring also.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|