Farmall & IHC Tractors Discussion Board |
Re: Farmall 460 w/ loader and #540 Plow?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAW in IA on April 23, 2005 at 15:47:10 from (12.219.45.39):
In Reply to: Farmall 460 w/ loader and #540 Plow? posted by bremic on April 23, 2005 at 13:48:03:
In sandyground it amypull it but it would bea load. The 460 never was known for lugging. If it goes cheap enough, a bottom can be dropped easy enough to make it a 3 bottom plow. As for plowing with the loader on it, it will help to hold the front end down. The mounted plowsmake them quite light in the front when transporting. Dad had a 350 with a 3/16 plow, and the fropnt end was in the air all the time. Could take off in 4th with the plow raised and put it in the ground! 460 may be a little heavier in front, so don't know how it would be.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|