|
Farmall & IHC Tractors Discussion Board |
Re: steering
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by janicholson on April 24, 2005 at 11:18:04 from (66.173.50.85):
In Reply to: Re: Derek Broerse posted by Derek Broerse on April 24, 2005 at 10:34:21:
On the issue of hard steering, from the posts so far one item has been overlooked. The issue of the greasing of the bolsters is critical. If, as stated, the fittings seem to be screwed into blind holes, they in effect are. extreamly old oxidized grease will collect bushing particles and harden into a plug that is impossible to grease through. Pull the fittings and use a small drill bit (in your fingers or pliers, not a drill motor) and pick out all the black solid crud in the hole. Even if you did force grease in the bearing the crud would be forced into the bearing, not good. Open your grease gun and pull the plunger back to the notch like you were changing the cartridge. pour about 30ml an ounce of engine oil down cartridge, and replace the pump w/o spilling the juice. Next raise the front end (needed in prep for axel repair anyway) and pump in the oil. This washes some of the dirt out (oil has solvents, detergents etc,) and continue till clean grease comes out of the shaft. Turning the steering can also help limber things up. I like Ford automotive specification graphite based chassis grease, it is slippery stuff, and hangs in journals better in my opinion. LOL JimN
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
