Farmall & IHC Tractors Discussion Board |
Re: 1466 HYD
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Yellott Canby on May 10, 2005 at 18:51:27 from (205.208.129.147):
In Reply to: 1466 HYD posted by forgetit 27946 on May 10, 2005 at 10:44:23:
Hello, Are the arms stuck in the up postion? I had this happen on my 1466. The arms stuck up and would not come down. Had to take the top link holder of which opens up to the main rear housing. There was a spring loaded piece there that had come of its holder, had over extened.Seems like it happened when I lowered the arms. This happened several times until I welded a bolt on the spring loaded piece to keep it from over extending and it works fine now. Kind of a hard thing to describe and probably only is relevent if the arms are stuck in the up position. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|