Farmall & IHC Tractors Discussion Board |
bolster seal on 350
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jerry davis on May 27, 2005 at 16:36:01 from (64.53.33.60):
I'm rebuilding the bolster on my 350 rowcrop and have allmost all the parts from caseih but one seal. the lower seal old pt nmumber is 364 468 R91 my local dealer has ordered is twice and both times it comes in with a too small seal. Does anyone have a national or napa number I can use? BTW dumb question time, after reading many posts on this subject, and looking at bob M's pictures, can anybody tell me the correct way to install the lower spacer and thrust bearing? Can't tell from parts breakdown and mine didn't even have some parts in it on teardown. New bearing has numbers on outside should it be installed rightside up or down. bottom spacer flat up or down Thanks Jerry
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|