Farmall & IHC Tractors Discussion Board |
Re: super m carb serial number
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on June 15, 2005 at 06:49:47 from (66.228.96.226):
In Reply to: Re: super m carb serial number posted by farmall on June 14, 2005 at 22:03:56:
Should be ok, When you run a hotter 12 volt coil with points, you run a resistor to keep the voltage level down, so it does not burn up the point contacts. Your doing the same thing by using 12 volt coil, and only putting 6 maybe 8 volts of power into it, it does the same thing as the resistor your not feeding the ign the full 12 volts. A good coil to try is the ACCEL super stock coil sold at napa. if your system was 12 volts, you can run this coild with no resitor, and full 12 volts, and not burn up the point contacts. Will work with under 12 volts too. Chad
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|