Farmall Tractors Discussion Board |
Re: Cub Oil Leak
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Chris on December 16, 1999 at 09:00:13 from (216.176.147.23):
In Reply to: Cub Oil Leak posted by Jim Murray on December 16, 1999 at 08:34:59:
First, that cast unit with an oil gauge on it is your oil filter. If you remove the hex bolt and pull the top off, you'll see the oil filter element inside. I've heard some people say that if you don't tighten the bolt down properly you can get a leak. For you, that gasket is probably shot. Since you just bought it, you should change the oil and the filter. CaseIH has these parts, and you may be able to get them at NAPA. I live in Northwest IN, and run straight 30W oil with a bit of Marvel Mystery Oil year-round. (It's difficult to remove the filter with the hood on, but can be done.) Second, initially the coolant level should be filled to the neck of the radiator. After some time, a little coolant will flow out and will drop a bit to the proper level. For my Cub, the coolant has settled to just below the top of that metal "bar." (The metal bar is a continuation of the coolant inlet--the bottom of it is open.) Hope this helps, Chris
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|