Farmall & IHC Tractors Discussion Board |
Re: 300 question.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scruffyia on July 06, 2005 at 11:27:41 from (206.195.193.254):
In Reply to: 300 question. posted by Kelly C on July 05, 2005 at 20:14:38:
When my M acts up I take a little tester and start at the ignition switch and work to the sparkplugs. I make sure power is getting to the ignition switch, turn on the switch, make sure it's getting through the switch with it turned on, then I check the connections at the coil to make sure they are getting juice, and so forth. If I find juice is getting to one thing but can't get juice out of it, like juice getting to the coil but nothing coming out of it, I replace the part. The alternator doesn't play a part in getting spark. Meaning even if your alternator isn't working, with a good battery the tractor will turn over and start and run until the battery goes dead. So a no spark condition is something between the battery and the spark plugs. later, scruffy
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|