Farmall & IHC Tractors Discussion Board |
Re: Rear axle bearing replacement on an H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Aces on August 09, 2005 at 05:07:28 from (67.0.20.150):
In Reply to: Rear axle bearing replacement on an H posted by Dave in CT on August 08, 2005 at 23:51:28:
Dave I did nit read all you have listed. But 1 & 2 are right. Remove the wheel and housing end cap and PTO. Now through the PTO hole remove the cap screw from the end or the axel and take the wasker off the screw, put the screw back into the axel all the way get a hard block of wood or a shaft that will fit between the left and right axel screws. Now as you screw the capscrew back out it will bush the axel out of the housing. The end cap holds the outer bearing no retainer. In # 3 for get the nut under the bull gear. You said axel bearing so I don't know what carrier you are talking about. Behind the bull gear there is a retainer for the inside bearing. You will have to pull the bull gear back and move it to the other side to get in behind the gear to get at the retainer. If I where to do this job I would remove the axel housing for inside bearing. When you go back together you will need a bar to lift the bullgear some to get the axel to go into the gear, if you don't remove the housing you will need to move the bull gear back and to the other side as best as you can that's why I say forget anything under the gear cause you need to move it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|