Farmall & IHC Tractors Discussion Board |
Re: hydro pump mystery
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ACHodges on November 25, 2005 at 19:47:38 from (4.253.72.12):
In Reply to: Re: hydro pump mystery posted by EL Toro on November 25, 2005 at 10:19:33:
The seal is on the shaft between the gear that is driven by the timing gear and the drive gear inside the pump. The whole pump must be removed from the engine block. The gear that is driven by the timeing gear is held on with a nut and a bend over locking washer. Once the gear is removed the shaft and drive will slide out. There is an o-ring inside the caseing where the shaft goes through. The kit will have a thick and a thin o-ring to choose from. If yours uses the thick o-ring and the shaft only has a slight indention and not a deep groove a redi-sleeve will not be needed. You will need to make a tool to insert the shaft back into the caseing without damageing the o-ring. Made mine out of a steele bushing. Have fun. Craig
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|