Farmall & IHC Tractors Discussion Board |
Re: Farmall C touch control
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on December 23, 2005 at 17:07:23 from (66.173.50.55):
In Reply to: Farmall C touch control posted by Nat on December 23, 2005 at 15:39:33:
Others have stated (and I concur) that the hydro pump on a C is modest at best. When used for articulating a 3pt they either lift well for short lift stroke, or only light loads with a stroke of 15-18 inches. Putting a cylinder on the hitch results in similar issues. If large enough to do the job, they are slow slow slow. If small enough to move swiftly, they are wimpy. A solution may be to use a upper cross shaft with arms that have multiple holes at differing lengths from the anchor point. This would allow the hitch to be adjusted to be powerful and limited in lift height, or long in lift and weak. (or inbetween if several holes were drilled. Tie rod ends from line haul trucks are great on the top of the lift links. I hope this helps. JimN
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|