|
Farmall & IHC Tractors Discussion Board |
What caused this engine slowdown?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmall Frank on January 14, 2006 at 17:02:07 from (69.76.145.131):
Put a new thermostat in my 400D, and started it up on gas. Left it on gas for about 5 minutes, then noticed it starting to labor and slow down, so shut it down. Waited a few minutes, than started on gas again, left it there, and after 5 minutes it started to labor again and almost shut down, like it was pulling hard. I turned it off before that happened. Went up the the radiator, not knowing what the heck just happened and noticed it seemed real hot. Took off the cap and it was boiling inside. The head was hot. Said to myself, bad stat. Took it out. I must have been sold the wrong stat. It fit up in the housing just right, but after reading the instructions, found it needed to be installed with the pellet towards the engine. It will not fit that way. Like I said, it fit like a glove the wrong way. Put the old stat in and it worked like it should. Should have never got a new stat, but the old one looked like it had been through a war, so ---. My major concern is if I damaged something trapping the heat in the head with boiling water? What caused the engine laboring?
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
