Farmall & IHC Tractors Discussion Board |
Re: Thanks for starter help and another question a
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on January 15, 2006 at 19:15:52 from (66.244.90.98):
In Reply to: Thanks for starter help and another question about posted by J Schill on January 15, 2006 at 18:42:42:
JS, Im not a fan of most snake oils and additives. That 87 octane is plenty high to prevent pre ignition spark knock unless your souped up to very high compression. Its true the lead in gas can provide some valve lubrication and protection, but it will take a longgggggggg time to make much difference in valve wear and recession unless youre using that tractor under full and hot n heavy loads for longgggggggg periods of time. Hardened valve seats are also possible if wear is really a problem. About the only additives I use for long storage periods are Sta Bil to help prevent gum n varnish and increase the gas shelf life plus some low ash 2 cycle oil added to the gas which I believe may leave some of a protective film deposit in the carb or tank etc to reduce oxygen contact and oxidation PLUS it can serve to some degree as a top end and valve lube. John T
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|