Farmall & IHC Tractors Discussion Board |
Re: Throttle adj. Super H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 19, 2006 at 05:59:48 from (199.17.6.175):
In Reply to: Throttle adj. Super H posted by Andrew Z on January 19, 2006 at 04:52:32:
Others will correct me if I am wrong. There is (usually) an area of throttle lever motion that does nothing at the idle end of the travel. This can be as much as 1/5 or so of the entire sweep. This is more or less the space that assures that when the lever is at idle, that the governor is fully in that position. Shimming that spring will reduce this slack, but it may not change the total wide open setting. The main ingredient is to assure that the governor is being fully opened by the lever for full power operation. (High Idle, and full load speeds) If the throttle is opening the gov. control lever all the way when pulled back fully, then I'd leave it alone, it needs some slack in the system at that end. Good luck, JimN
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|