Farmall & IHC Tractors Discussion Board |
Re: Disking with my Super M... what disk would be
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on February 26, 2006 at 03:58:38 from (209.226.247.68):
In Reply to: Disking with my Super M... what disk would be a go posted by Tim Malin on February 25, 2006 at 20:40:16:
Tim: Forget about width of cut, for a good disk, your going to require a minamum of 1.25 hp per 16" blade and depending on a number of factors that could run as high as 1.75 hp per blade. 18" or 20" blades will require more hp. Depth of cut and soil are unknown factors as well. Looking at it from this point of view, a 36 blade disk is plenty load for a Farmall M, SM, 400, etc. Sure it may well pull a 48 blade disk 3" deep, but what are you going to do if you wish to disk 6" deep. I know most of these guys will tell you, you'll never need to go 6" deep. However if you want smooth fields, it is ocasionally necessary.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|