Farmall & IHC Tractors Discussion Board |
Re: puller with diamentions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Keith-OR on March 14, 2006 at 11:56:56 from (207.200.116.5):
In Reply to: Re: puller with diamentions posted by Chris in Washington on March 14, 2006 at 10:17:32:
Chris, lunch time. Lets start from the being, the reason I used 3/4 altheard is that is what I had on hand. I later needed to make a tool to push the pulley back on. I had a 40 inch piece of 5/8 althread and that is the size of bolts that holds the bolster on the front of a SC. the square tubing I have in picture the 5/8 goes thur it and is bolted to front of engine, jack pushes against it and between jack and pully I used the round piece I cut out of the 3/4 plate. Assembled it looks like the puller without the bottom plate Don't know if I have a picture of pusher put together. I should have taken one when I was pushing pulley back on. Chris, I think you could use 5/8 althread for the puller as well as the tool for re-installing front pulley. Like I said all the material I used is what I had on hand at the time. I did not see the 5/8. :>( Also you can use one piece of square tubing, just drill 3 holes in tubing. If I ever Build another one, I am going to simplify it, 2 pieces of 5/8 althread, 1 piece of tubing w/3 holes HTH If you have any more question just email me Keith & Shawn
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|