|
Farmall & IHC Tractors Discussion Board |
Hydraulic pump Farmall C
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill WIneman on April 19, 2006 at 15:08:35 from (71.8.247.130):
From reading the posts on the board it appears that oil getting past the worn o-ring on the C's pump drive is common. I've been "making" engine oil for the past few times I used the C to mow with so I figured it was time to get a pump kit and do the job. I figured as soon as I repaired the Touch Control unit so it didn't leak this would be the next item. Had the local Case IH dealer order the seal kit they took the number off of the old pump and it looks like the right o-Rings etc are there. But there are also some parts that are not in the original pump. I know it is not unusual to have parts for sevral applications in one kit but I wasn't sure. I have the Blue ribbon touch control service manual but the pump diagram is limited. Any advice from those who have already went down this road? Is it difficult to get the pump shaft through the new o-ring without damage?
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
