Farmall & IHC Tractors Discussion Board |
Re: New Tahrs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Quebec Red on April 24, 2006 at 11:22:28 from (70.83.254.155):
In Reply to: Re: New Tahrs posted by P Backus on April 24, 2006 at 11:06:50:
here in Quebec most combines run R2 tires, and some tractors as well. Fall rain is a killer here, and no till is questionable as we loose too many days in the spring waiting for the ground to warm up, thus fall tillage, especially in corn residue is almost a must. I ran R2 tires for years. They were always mounted on rims, so changeover was not too bad. They were loaded, too. Fully understand the longer tow cable procedure, all too well. Had an IH 1460 4x4 with 30.5x32 R2 tires, full grain bin, pull a Ford 8000 truck with a 20 foot box full of wet corn out of a mud hol;e. The Ford was down to the frame. That 1460 just put out more smoke as the Hydro lever went ahead in first, sat down and PULLED the truck out. Left a h-ll of a hole, and 2 deep long ruts, but she got her out!!!! R2s really pull if you have a bottom under the mud....QR..
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|