Farmall & IHC Tractors Discussion Board |
Re: question about the regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on April 27, 2006 at 19:09:27 from (66.244.90.5):
In Reply to: question about the regulator posted by Levi K on April 27, 2006 at 18:47:45:
Levi, as we told you somewhere earlier down below, the alternators rear main output stud is what now wires to the Load (NOT to battery/starter) side of the ammeter and I use 10 Gauge with the GM 10SI Alternators. I cant say for sure, but in your picture the wire on the right looks larger and if so may well be the one that used to run from the old regulators BAT terminal up to the load side of the ammeter. If it runs there and is 10 gauge (likely could get by even with 12 gauge) that wire could be used to feed the alternators output up to the ammeter. However if you wanna just attach those wires to the old regulator just strictly for looks, do like Old said and cut them and just have them as dummies in which case you could run a new 10 gauge from the alternator to the ammeter. John T
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|