Farmall & IHC Tractors Discussion Board |
Re: fitting a woods 42a to a farmall cub?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmall Ed on April 28, 2006 at 05:22:10 from (69.245.54.29):
In Reply to: fitting a woods 42a to a farmall cub? posted by buffc on April 27, 2006 at 15:49:19:
Buff, I dont understand exactly what you are saying, I just installed a 42 inch belly mower on my cub for the first time the other day, My bracket sits on top of the drawbar and clamps on with to steel straps. If your pulleys are in the center that would make them out of line with your power take off pulley. I am sure there are some people on here that can give you better advice than I can. Does you tractor have hydraulics? If it does let us know, I may be able to help you with that. Have a good day.Ed
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|