Farmall & IHC Tractors Discussion Board |
Re: tractor gears
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob M on April 28, 2006 at 07:01:41 from (151.190.254.108):
In Reply to: tractor gear,s posted by kirk in Ks, on April 28, 2006 at 05:44:19:
Kirk - The M and W-6 are geared differently to account for the different rear tire diameters. However travel speeds are close to the same so driving/shifting either tractor is the same. --- You can smoothly shift either tractor from 4 5 like this: 1 Start on a hard surface; level or slightly downhill. (The tractor must be able to coast for several seconds without slowing down too much...) 2 Get the tractor going at max RPM in 4th gear. 3 Simultaneously step on the clutch and close the throttle. 4 While the engine RPMs coast down, move the shift lever to neutral. 5 The instant the engine hits idle RPM, in quick succession release the clutch, step on it again and move the shift lever to 5th. If you do this right the lever will drop right into 5th without a hint of gear clash... 6 Finally release the clutch, open the throttle and enjoy the ride! It takes a few minutes of practice to figure out. But once mastered it it works great!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. Its amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. Whats even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|