Farmall Tractors Discussion Board |
Re: IH350G Utility 2 pt - 3 pt conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by MrGadget on January 17, 2000 at 06:42:28 from (205.240.115.32):
In Reply to: IH350G Utility 2 pt - 3 pt conversion posted by PD2 on January 16, 2000 at 20:41:40:
I have a 350U w/fasthitch. I have two lower control arms with the ball socket the slide right into the fast hitch. No, they are not for sale, but have seen similar at TSC and Country General. Problem is...no top link mount. You can make one yourself by attaching a U-clamp to the top lift arm shaft or weld up/built a bracket that mounts into the 3 holes on the back of the rear end housing to mount the top link. As mentioned in earlier post...check out Worksaver's website. Nice line drawing of what you need. From their drawing, you can decide to build yourself, or buy from them. Since I already have lower control arms, I intend to see if they will sell me the top link bracket seperately. Just haven't gotten around to it yet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|