Farmall & IHC Tractors Discussion Board |
Farmall H governor need some advice..
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by River Bottom Farmer on June 29, 2006 at 19:26:31 from (64.12.116.65):
Howdy fellers,I have developed a leak out of the throttle shaft between the block and governor housing.I have an extra governor off another engine and wanted to go through it and swap them out so I can keep using my H for all my chores.I know its not supposed to be to complex of a repair but can someone tell me where I can get a seal for the throttle cross shaft.I wanted to get an idea of where to start and also about the cost of the repair.I would just swap them out but I want to be sure I have no leaks.Also can an outer axle seal be purchased at NAPA or other automotive sources,got the last seals at CIH dealer and it cost nearly forty dollars thought that was sorta steep....RBF
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|