Farmall & IHC Tractors Discussion Board |
One more for Bob M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jimer on July 11, 2006 at 19:19:42 from (198.174.213.208):
Re 12 v conversion on 300u. I got your diagram, and tonight I traced all the wires with a ohm meter. Finally found them all, the last one took about an hour. It is the one from the alternator to the ignition switch, which was broken off and disconnected. Before it appeared to be charging a few amps, and discharging a few amps with the lights on. Put it back together and started it up, holy buckets the amps jumped to +45 then came down to about 35 when I stopped it. But, stopping it wasn't quite right. Could not do it with the ignition switch. If I remember right, I need to install a diode in the wire from the alternator to the ignition switch, is that right? The only difference I saw between the schematic you provided and my tractor is that my lights get power from the alternator post instead of the amp meter. Please advise on the diode, and thank you for all the help!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|