Farmall & IHC Tractors Discussion Board |
Re: Ih 574
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fromjb2 on August 30, 2006 at 17:04:32 from (69.198.143.165):
In Reply to: Ih 574 posted by Bob Lang on August 30, 2006 at 14:59:03:
Hi Bob, do you mean the rockshaft arms at the back of the seat or the 3pt lift arms? If it is the 3pt lift arms maybe the roll pin that locks the leveling yoke in the leveling screw housing in the non float position is missing or broken. The roll pin with a locking key goes in a hole in the levelling screw housing just above where the levelling screw housing attaches to the 3pt lift arms. When this roll pin is removed it allows the 3pt lift arms to float independently. We used to pull these roll pins when we used the tractor on a 3pt corn planter so if a rear wheel dropped in a hole the other end of the corn planter would not come out of the ground. Hope this helps JB2
Replies:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|