Farmall & IHC Tractors Discussion Board |
Re: One more time please! I need 2 parts and help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on September 01, 2006 at 10:35:16 from (199.17.6.122):
In Reply to: Re: One more time please! I need 2 parts and help posted by JayWalt on August 31, 2006 at 11:57:43:
With the throttle rod off of the governor (shown in the above picture assembled) move the throttle lever at the steering wheel to maximum full throttle position. Then take the governor control arm and move it as far as it will go toward the full throttle direction. the hole in the gov. lever should now be just short of the location of the pin sticking out of the throttle rod attachment. Thus pulling the governor wide open when the lever is pulled all the way. If this is the case, the system is as good as it can be. They are quite sloppy and often have ineffective lever travel in the idle area. If it is not pulling the governor to its limit, shorten the rod adjustment till it reliably does so. If your unit has external linkage to the carburetor, leave that adjustment alone, or use written instructions to adjust it, that adjustment can overspeed the engine. The one described above cannot. JimN
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|