Farmall & IHC Tractors Discussion Board |
Re: farmall 350 utility
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on September 06, 2006 at 09:31:02 from (216.208.58.141):
In Reply to: Re: farmall 350 utility posted by Brycen on September 06, 2006 at 08:29:21:
Brycen: Is the tractor equipped with TA as in Torque Amplifier. The lever for that if so equipped would be to the left side of steering colume just above the clutch pedal. There will be a network of linkage between this lever and clutch pedal. Those linkages being out of adjustment can create the problem you describe. Your problem can also be caused by a bad pilot bearing, clutch disc sticking on shaft, could be a warped clutch disc and even a faulty presure plate. First you make sure your adjustments are correct, and if that doesn't cure the problem, you'll probably have to split the tractor at the clutch housing. If you don't have an operator's manual, it would be best to get one. These adjustments are just about impossible without the manual. It has to be adjusted to the letter and by the book, close doesn't count with these. The operator's manual gives a diagram for this adjustment complete with directions.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|