Farmall & IHC Tractors Discussion Board |
Re: ROPS for a B414
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Big Don on September 07, 2006 at 12:36:17 from (74.117.164.104):
In Reply to: ROPS for a B414 posted by wkw on September 07, 2006 at 08:26:30:
If you go to www.laurin-inc.com they list a ROPS (roll bar) for the B414. They are located in Laval Quebec. Yopur local dealer may be able to get it from Laurin for you. I would recommend you not have one made by a local welder as the mounting points and stresses need to be correct since your life may depend on it. If you add a roll bar, make sure you add a seat belt and then USE IT every time you get on the tractor. (if the tractor rolls over and you get thrown off, the roll bar might not do much for you) Don
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|