Farmall & IHC Tractors Discussion Board |
Re: 140 pump pressure and volume
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on September 18, 2006 at 03:59:40 from (216.208.58.192):
In Reply to: 140 pump pressure and volume posted by BEWILDERED on September 17, 2006 at 18:51:29:
Presure is somewhere in the 1000 to 1200 psi, GPM is 4.5. There were loaders built for them, not many ever sold, compared to the number of tractors. Front end of this little tractor will be the weak point. I personally wouldn't touch it. I've seen a few busted up offset tractors from loaders. There are folks that will tell you the loader doesn't lift enough to break front end, I understand about 500 to 600 lbs is the limit. That is still quite a lot 4' in front of axle if one hits a severe bump. I may be a bit prejudiced, personally I got rid of my last tractor loader in 1978. IH 2000 loader on a Farmall 560. I would never install another loader on a conventional farm tractor. I went to a 40hp skid steer, it ran circles around 560 at about 60% of the cost.
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|