Farmall & IHC Tractors Discussion Board |
Re: Cutting a flywheel Gauger
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill in Oh on October 17, 2006 at 09:51:26 from (71.79.44.154):
In Reply to: Cutting a flywheel posted by Gauger on October 16, 2006 at 19:21:28:
I personaly would not cut the flywheel on a lathe. i would prefer the grinding machine over the lathe.what happen with lathing is the die pulls metal anywhere there is cracks or hard spots that the naked eye can't see.I just got in from the machine shop with a 1066& 1486 flywheel that was ground he took 0.60 from one 0.48 from the other.really nice job on them he ground top decks& lower decks the same 80 bucks each.hopfully while not on the dozer today i will get one of these jewels back together the guys around here won't even consider the lathe on these big tractors them flywheel will explode.SH maybe?
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|