Farmall & IHC Tractors Discussion Board |
PTO snap ring design problem in early 560's and si
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Charlie on October 26, 2006 at 06:26:48 from (141.133.82.91):
At the inner end of the PTO output shaft in the clutch type PTO units on the 340, 450, 504, 560 and other tractors, there is a clutch retainer snap ring or retaining ring (no. 47 on 560 diagram, part 373588R1, that is used with the original shaft, 373546R1. This must have proven to be too weak, so the ring is not even replaceable, and the new one is twice as thick (1/8 inch square crosssection) but must be installed with the new R2 version of the shaft. Does anyone have any experience with this issue? I'm thinking about widening the snap ring groove on my lathe to take the new one, but that would leave only a very thin shoulder. Don't know if the newer shaft had a different end profile. Thanks. Charlie
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|