Farmall & IHC Tractors Discussion Board |
Re: C-123 engine applications and serial numbers
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David Lindsay on December 26, 2006 at 15:29:58 from (216.167.225.224):
In Reply to: Re: C-123 engine applications and serial numbers posted by Stan(VA). on December 25, 2006 at 18:49:49:
I've had a Farmall for 20 plus yrs sitting in my barn and never tried to find out what it was until this week when I found this site. It has been pickled but started up with some gas and a short pull. I'm trying to verify if it is a 1955 Model 200. The engine is embossed C123 and 354898. As well engine is stamped 11347. The plate on the clutch housing is 5900 J. The grill has two vertical full length openings below the IH chrome badge. On either side is a pattern of horizontal openings layed out, two space six space six and space two, which I understand was the pattern after 1954. Any info is appreciated. THx Dave
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|