Farmall & IHC Tractors Discussion Board |
Re: Clutch shaft coupler plate
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob Kerr on July 04, 2007 at 22:30:19 from (64.12.117.8):
In Reply to: Clutch shaft coupler plate posted by IndianaRed on July 04, 2007 at 08:03:02:
I will have to think here for a min, It is late now and am getting tired, but here goes. I think I had gotten the shaft slid in and had trouble like that also, so I took off the bolt for the trans input shaft and got the shaft on all the way ( I think it may have not gone all the way into the pilot bearing)then put the bolt back in and then slid the ring inbetween the flanges and then slid in the rubber washers with retaniers. I will have to tell you, the manuals are not much help for this, I plan on taking mine back apart tomorrow if the rain lets up and the puddle under the tractor isn't too deep, I may write down the process so I can help everyone out. Where in Indiana are you?
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|