My parts book for my SuperC only shows the integrated PTO and pulley unit in a single housing. (My book for As and Bs shows all the various combinations, PTO only, pulley only, PTO and pulley.)
If what you busted is just the retainer that holds the outer bearing and seal for your belt pulley then, yes, you can dispense with the shaft to the pulley, tap out some gasket material to seal it, and fab up a cover to close it up.
If you busted up the cast housing for the whole unit, you'll find yourself McThreaded unless you can find someone who can weld up the cast and machine down the surface where the pulley flange was to take a gasket and plate. If you need to run it an can get by without the PTO for a while, you can remove the entire unit and do the same make-a-gasket-and-plate exercise to closr that up until you can find a replacement.
I know there were different editions of the parts book, so maybe another one shows something else.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.