Posted by Dellbertt on July 28, 2008 at 17:55:07 from (209.172.22.70):
This is a 1965 Case 66T Rotary Cutter driveshaft pictorial.
The rear shaft housing (bottom left) nylon bushing (10), washer (9) and snap ring (8) are all missing so the shaft housing is flopping when in use.
I have searched the internet with no luck and my local Case IH dealer and the regional parts mgr both say they cant find any record of a 66T ever existing until I should them the owners manual and a parts catalog.
I have to take it apart no matter what I do. I could just go to the local Motion Industries and match up a bushing best I can, one guy suggested I make hardwood wedges and drive them between shaft and housing to keep it from moving.
Has anyone taken the housing off completely? I don’t see any reason that wouldn’t work except for the safety aspect.
If I do find the parts, how does the snap ring go on? There doesn’t seem to be enough room to snap it in place except to put it in place then shove the housing over the retainer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.