Farmall & IHC Tractors Discussion Board |
Re: steering
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Larry24d on April 02, 2000 at 11:41:52 from (209.242.110.65):
In Reply to: steering posted by wayne on April 01, 2000 at 16:45:05:
there is no adjustment on the worm gear...however i had one that the bearing on the end was loose..you can also pull the gear and change the position of it 180degrees...this will put new teeth where it sits on center...you can do this without pulling the front casting...if I were you I'd pull the cap on the front and wiggle the shaft and see if you have end play...it may be that you have the same thing I had..I found that the teeth on the worm gear and the other gear were almost perfect..the bearing I'm referring to is held in a fixed position by the casting on one end and a bearing retainer on the other..there is a nut holding the bearing on the worm gear shaft if this is loose that would allow the worm gear shaft to move in and out and allow slop...I'd also make certain my steering U joints were good... hope this may be of help...
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|