I"ll throw in a 3rd for the soldered ends. I just made a new cable for myself out of 2/0 guage marine grade cable. A little pricey, but it"s worth it. I used a soldered lug on one end, and a soldered ring on the other. Lots of flux, and be warned - It does take a surprising amount of solder to fill the ends properly. To make it super neat, I slipped on a piece of shrink tubing beforehand, then after I was through with the torch and solder, slid it up just over the end of the lug/ring and heated it gently to shrink it up. Boy does it look nice! Shrink tubing hides the end of the cable insulation which gets just a little burned by the torch and seals things up to make it a virtual lifetime lasting cable.
It's a 5 minute job, very much worth the added expense and effort. I've looked at your photos of your beautiful shop and the thoroughness with which you are going through that tractor, and I'll be honest - my cable looks like something you would do!!!
By the way, mine is still the original 6 volt with the points, and boy does it crank nice now with good connections and big cable!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.