Posted by Melvin Ware on September 11, 2009 at 11:24:42 from (4.152.108.73):
I'm still trying to loosen the water pump pulley on my Farmall M in order to replace the generator belt. I have the locknut and set-screw out but can't get the pulley to budge. Have soaked the threads with plenty of PB blaster and hammered against the pulley "hump" using a rectangular stick of oak. (Still looking for a brass rod but no luck yet.) On closer examination, I noticed the two sides on the "hump" are not square as I first thought, but angled in toward the shaft. It's the same on both sides and appears symetrical. Is the pulley made this way and for what reason or did maybe a previous owner knock the corners off while loosening and tightening the pulley? The angle makes it hard to hold anything the hump to give it a decent lick. Any thoughts or suggestions?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.