Posted by Tom Fleming on April 22, 2010 at 17:52:45 from (67.20.229.132):
In Reply to: fresh engine posted by 706 Farmall on April 21, 2010 at 19:27:14:
Wow. I am not going to point at any single post, but WOW. The difference of opinion here is significant.
this one might make it up into the league of spark plugs, oil, and 6 vs 12 volts.
One thing it looks like everyone agrees on. assembly lube. From my perspective, priming the oil pump is a good thing. If we go into how to prime the pump, then the opinions start to go in different directions. I turn the engine over with the starter as stated to prime the pump and get oil moving through the journels. this fills the crank oil galleries, and get oil through the block. Then I start it right away. Not looking for anyone to agree, just thought I would share what I do and that it works for me.
So, summary. Use assembly lube and prime your pump. Your milage may vary................. :roll:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.