Farmall & IHC Tractors Discussion Board |
F-12 Problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RB on May 29, 2000 at 15:31:20 from (12.77.31.146):
FInally a problem with something other than my F-14!Budy of mine bought a F-12.No serial no. plate but by the casting codes its a 36.WHen he got it it had a hole in the block,so he bought a block that is a 35.We rebuilt it and this morning was the first time we fired it off.We wore our arms out turning the crank so we tried pulling it.It hits and misses alot but will not start.It occasionally backfires and when it does it sounds like its doing it on the intake stroke like its sucking in the backfire.Checked engine timing and mag timing and all is right on.No sticking valves and its getting gas to the plugs.All of the usual has been done so I can rule out plugs,wires.points,etc. Any clues?
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|