Farmall & IHC Tractors Discussion Board |
H Wheel Weight Removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on June 18, 2000 at 11:43:48 from (12.75.196.98):
Thanks to semoREDNECK we were able to remove a couple of wheel weights on my 1946 Old Red H yesterday. It has doubles on each side. Most of the embedded bolt heads were square but of the smaller variety. We turned the heads 45 degrees to the square indentation then hammered in a bolt in the upper corner so the head wouldn't rotate while removing the nut. These bolt threads have at least 2 coats of paint on them. I still have one bolt that is a 1 1/6 badly worn hex head and we had no luck keeping the head from turning trying to remove the nut. I had an 8 point socket on it and it rotated in the socket. Other than buying a 6 point 1 1/16 socket, are there any successfull techniques you have used to keep the bolt head from rotating while removing the nut? Thanks in advance!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|