Farmall & IHC Tractors Discussion Board |
Bolster bushings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom A. on July 26, 2000 at 18:12:09 from (208.241.20.10):
Just finished replacing front bolster bushings on my "H" with catastrophic results. After installing the upper, proceeded to install the lower, but wouldn't go. Then took the pivot shaft and stuck up through the assembly, thinking the lands on the pivot shaft would serve to drive it up with assistance of a hydraulic jack under it. Unfortunately, tractor began lifting up off the cribbing supporting front end. Upper bushing was ruined by the keyways on top of pivot shaft. Lower bushing seized and had to cut it out. Now I have it all over to do again. Would lubricating the new bushings be helpful, or dry ice to shrink them be an advantage. Any you old timers got a solution for me? Tom A.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|