Posted by Jim Becker on May 10, 2011 at 19:12:52 from (173.57.144.251):
In Reply to: ethenal posted by Alan Harmon on May 02, 2011 at 19:16:37:
The amount of water that gasoline or a gasoline alcohol blend can hold depends on temperature. If the mixture is saturated and the temperature subsequently reduced, there will be phase separation with the excess water settling to the bottom. The lower the temperature, the less water need be present to have phase separation. Even at 0 degrees, an E10 blend can hold more than 0.3% water without phase separation. Properly handled and stored gas will not have that much water in it.
Adding a 12oz bottle of methanol when you put 20 gallons of E10 in your tank, will run the total alcohol content from 10% up to nearly 10.5%. That will let the fuel hold a little more water, or equivalently bring the temperature of phase separation down a little. But if your fuel is that contaminated, you have other problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.