Posted by charlie M on September 11, 2011 at 07:00:56 from (74.34.200.218):
I've been wanting to start a new tractor project for a long time but they always seem to be either too much money for my wallet or way to far away. This week a guy had an A for sale just around the corner from me and I grabbed it. Glad I did as he had a ton of guys calling for it. Guy said he replaced 3 sleeves that were cracked and replaced all rings. He couldn't get it to run and since he's really more of a JD guy decided to sell it. I got to look at it this morning and it has virtually no compression. I pulled the head. He said he cleaned the valves but looking at them it looks like they were originally badly corroded and all he did was free them up and maybe wire brush them. I'm thinking valve job. My question is if the pistons look good with what he did is it most likely the problem is the valves? Head gasket was tight. Anything else that could cause a compression problem. Valves were set with the correct clearance. Is it cheaper to by a rebuilt head than for me to get the work done on this one?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.