Farmall & IHC Tractors Discussion Board |
H throttle action better
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Ed on August 30, 2000 at 15:38:15 from (209.240.220.143):
A few days ago I posted a message concerning my erratic throttle operation. Thanks to The Red and others who responded I went into the governor area and the thrust bearing is a little loose but not much wiggle. I also got into the throttle shaft connection under the slanted plate and lined it up according to my manual, as close as I could. There seems to be some looseness in the throttle rod connection. With the speed control full open and the throttle rod up all the way (butterfly valve open) the pin would not slide in freely. I adjusted the connecting rod all it would adjust and put it together. The engine runs OK now and follows the throttle settings pretty well. I did put a slightly shorter governor spring in also. The governor seems to operate very well. I would like to know if I can buy a kit to go in the governor. It seems everything is worn exessively but I can make it now with what I have done especially in my operations. Thanks again for your help. Ed
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|