Posted by Tony Woodrum on February 23, 2012 at 16:17:47 from (174.53.68.159):
Hey gang.... I hate too ask for help twice in one day but I ended up at my uncles house helping him work in his 39 F20. We have the engine on a stand and spent the day looking for a distinct "knock" in the engine while rotating it over by hand. We pulled the timing gear cover off, nothing......then back too the rear and removed the clutch, the flywheel (what a job...had too build a puller for that one)...and nothing there either. We finally found that the roller bearings in both ends of the engine has a little bit of play in them......seemd too be about 10 thousandths. This was up and down play as the crankshaft would move up and down this much. I know that's not a lot but at one point in exactly the same place....(top dead center on 1 and 4) you could hear and feel that little play. We thought we had a loose rod or wrist pin.....but everything checked out good there.
My question is: Should there be any play in the crankshaft at all??? We're going too replace the end seals while its down and will replace the end bearings also if needed. The bearings look like brand new and roll smoothly......but the play has us puzzled. Any info. greatly appreciated. Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.