Posted by JRSutton on March 26, 2012 at 10:26:27 from (75.130.109.233):
On the IH rake I've been working on - 4 bar enclosed gear.
at the gear end of the main reel, there's the big cast "eccentric" - with an outer raceway and inner raceway.
on the inner raceway, there's the main bearing where the reel's main shaft goes through.
On that same cast part, there a small hole in center of the whole part. I BELIEVE that's where the linkage from the lifting lever mounts - on a pin or bolt through that hole.
BUT - What does the end of the screw crank (for adjusting the pitch of the teeth) mount to???
The manual is very unclear on this.
Does it mount to the same hole in the eccentric that the lift linkage attaches to?
Or am I missing a part???
I know pictures would make this a lot easier but I of course can't find my )#(*$# camera right now!!
I do have one picture of what I'm calling the inner race of the eccentric. The small hole in the middle is the one I think the lifting linkage goes to.
In the manual there's a picture that makes it look like I'm missing a part that the crew crank attaches to (#3 in image number 9 if you happen to have the same manual)
But it's very hard to make anything out in that illustration.
My parts rake is a three bar - and it's VERY different in that area.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.