I'm going to give a different version. This excludes pulling, which to me is not real world. Unlike the early 560, the M/SM has balanced power to the ground. That is when the properly weighted tires start to slip the tractor loses rpm. The tractor is not overloaded as long as you can go from a standing start to full rpm in a few seconds. You should also be able to back off the throttle slightly, then open it up and the tractor will rapidly accelerate. Does plowing hurt the engine or rear end? -- not unless you overload it. I ran an H (think of it as a small M) for years pulling a 3 disk "breaking plow" in 2nd gear. The land wheel slipped slightly and probably could have used more weight. 3rd could be used for plowing in certain parts of the field, but that was rare. The H would pull a heavily weighted 6 ft tandem disk in 3rd gear, but almost never in 4th. Yes I know it will pull a wider one, but we got the best results with weight not width. I considered both of those tillage methods full load, for the gears we used. For all practical purposed 1st was too slow and 4th too fast. To sum up, combined with a little common sense on the part of the operator the tractor will tell you when it is happy, and when it is overloaded. The early 560 was overpowered for the drive train. Engine was happy, rear end hurt.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.