Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Farmall 400 dieseling: Update #2
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon on October 24, 2000 at 15:38:04 from (209.172.217.172):
In Reply to: Re: Re: Re: Farmall 400 dieseling: Update #2 posted by ltf in nc on October 24, 2000 at 08:02:42:
Well the exhaust is clear, even when going from idle to a higher speed fairly quickly, it stays clear. I took the thermostate out and compared it to another new one i bought the other day, it allows the same amout of water through when cold as the new one. They are both opening up at the correct temperature too. Today I did go ahead and recheck the timing. I set it per the book and is firing #1 at the 25 degree advance mark on the pulley. I did notice now when I start it, that it comes to life rite off the bat with very little cranking. Also, the dieseling isn't quite as severe, but it is still doing it and getttin a loud backfire when the engine does come to a stop. I am not for sure on the carb passages, they were clean when I rebuilt it, but could possibly be clogged now. One other thing, when I pulled the plugs out to check them, them was just a very light amount of soot on them compared to before. I really don't have any other carbs I could put on it to try. Thanks again!
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|