Posted by Ken Christopherson on September 16, 2014 at 09:31:02 from (184.97.151.107):
A while ago I asked some questions about a friend of mine's Farmall B he was looking to retro-fit a loader to. Tractor has been a good little tractor so far (he bought it in the spring), and I have had Farmall's in the past that I loved. I told him to go ahead with his idea. He picked up a loader from a local guy for $350 - It was mounted on an Allis WD. The loader seems a bit overkill for the B, so I advised him that when he does get it mounted, he will probably have to add quite a bit of rear weight to the tractor. Here are a few photos of the project so far. Looks to me like he is doing it right - making it quick release, and it sounds like all he has left to do is finish the welds, mount the pump and run his lines. Should be a good little tractor with his belly mower too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.